Mouse over ...
- a RAW_TYPE to check out the classification rule (M marks a multiple definition)
- a grouping rule to see the complete grouping rule
- a matching rule (e.g. '1,1') to see the product matching rule. '3,-1' means: all from same template, but at least 3.
Product tags etc. might be cut off, in that case mouse over the cell to see the full entry.
GT: mandatory validity (time match rule) for this gencalib is missing
<   : correct time match rule for gencalib (PREVIOUS); ?: wrong time match rule
T: mandatory validity (time match rule) for this match is missing
|| 7.0 : correct validity (time match) for this match

bottom | right	left
RAW_TYPE	ACQ_ECH	BIAS_BLUE	FMTCHK_SPEC_BLUE	ORDERDEF_SPEC_BLUE	EFLAT_SPEC_BLUE	DFLAT_SPEC_BLUE	WAVE_SPEC_BLUE	SCI_SPEC_BLUE
DO_CLASS	ACQ_ECH	BIAS_BLUE	ARC_LAMP_FORM_BLUE	ORDER_FLAT_BLUE	FLAT_BLUE	DFLAT_BLUE	ARC_LAMP_BLUE	SCI_SPECTRUM_BLUE
CATG	ACQUISITION	CALIB	CALIB	CALIB	CALIB	CALIB	CALIB	SCIENCE
Grouping rule	single	TPL.START	single	single	TPL.START	TPL.START	single	single
Index	1	2	3	4	5	6	7	8
Calibration cascade:
static calibs:	calib matches:
1 LINE_REFER_TABLE			1,1<				1,1<
5 SPEC_MASTER_FORM_BLUE			0,1<
8 LINE_INTMON_TABLE							0,1<
	15 ACQ_ECH							0,1 || 0.5
		16 BIAS_BLUE			5,-1 || 7.0	5,-1 || 7.0		5,-1 || 4.0
			17 FMTCHK_SPEC_BLUE	1,1 || 3.0			1,1 || 3.0
				18 ORDERDEF_SPEC_BLUE	1,1 || 3.0	1,1 || 3.0	1,1 || 3.0	1,1 || 2.0
					19 EFLAT_SPEC_BLUE			5,-1 || 2.0
						20 DFLAT_SPEC_BLUE		0,-1 || 2.0
							21 WAVE_SPEC_BLUE	1,1 || 1.0
Comments:
						Deuterium flats taken for the 346 settings only		very rarely used
Analysis (technical consistency checks):
raw_type* (CALIB only)	n/a	OK	OK	OK	OK	OK	OK	n/a
powered by QC [createCalibMap v1.3] last update: 2012-02-17T15:08:18

*raw_type: is raw_type used in cascade? (CALIB only)

top