Mouse over ...
- a RAW_TYPE to check out the classification rule (M marks a multiple definition)
- a grouping rule to see the complete grouping rule
- a matching rule (e.g. '1,1') to see the product matching rule. '3,-1' means: all from same template, but at least 3.
Product tags etc. might be cut off, in that case mouse over the cell to see the full entry.
GT: mandatory validity (time match rule) for this gencalib is missing
<   : correct time match rule for gencalib (PREVIOUS); ?: wrong time match rule
T: mandatory validity (time match rule) for this match is missing
|| 7.0 : correct validity (time match) for this match

bottom | right	left
RAW_TYPE	ACQ_ECH	BIAS_RED	FMTCHK_SPEC_RED	ORDERDEF_SPEC_RED	EFLAT_SPEC_RED	WAVE_SPEC_RED	SCI_SPEC_RED
DO_CLASS	ACQ_ECH	BIAS_RED	ARC_LAMP_FORM_RED	ORDER_FLAT_RED	FLAT_RED	ARC_LAMP_RED	SCI_SPECTRUM_RED
CATG	ACQUISITION	CALIB	CALIB	CALIB	CALIB	CALIB	SCIENCE
Grouping rule	single	TPL.START	single	single	TPL.START	single	single
Index	1	2	3	4	5	6	7
Calibration cascade:
static calibs:	calib matches:
1 LINE_REFER_TABLE			1,1<			1,1<
6 SPEC_MASTER_FORM_REDL			0,1<
7 SPEC_MASTER_FORM_REDU			0,1<
8 LINE_INTMON_TABLE						0,1<
	15 ACQ_ECH						0,1 || 0.5
		16 BIAS_RED			5,-1 || 7.0		5,-1 || 4.0
			17 FMTCHK_SPEC_RED	1,1 || 3.0		1,1 || 3.0
				18 ORDERDEF_SPEC_RED	1,1 || 3.0	1,1 || 3.0	1,1 || 2.0
					19 EFLAT_SPEC_RED		5,-1 || 2.0
						20 WAVE_SPEC_RED	1,1 || 1.0
Comments:
							very rarely used
Analysis (technical consistency checks):
raw_type* (CALIB only)	n/a	OK	OK	OK	OK	OK	n/a
powered by QC [createCalibMap v1.3] last update: 2012-02-17T15:08:33

*raw_type: is raw_type used in cascade? (CALIB only)

top