XEchelle

 

This chapter describes the use of the Graphical User Interface XEchelle. The interface XEchelle generates and sends MIDAS commands to the monitor. Therefore, all operations performed with the interface can also be performed manually by typing the commands on-line or writing a procedure. The interface is however a convenient additional layer of the software providing on-line help, visibility over the parameter values and avoiding syntax problems. These functions are particularly useful for parameter intensive procedures such as batch reduction.

Note

Using XEchelle requires that the described MOTIF GUIs have been installed on your system. Also this chapter must be considered as an operating manual of the graphical interface and assumes a general understanding of the Echelle context.

In this Section the following notations have been used:

Commands or keywords are indicated as:
	SET/ECH WLC=thar.bdf
Push-buttons and Menus are surrounded by a box:
and Labels or names are written in bold face:
	Calibration Frame: