next up previous contents
Next: Offsets between slitlets Up: Wavelength calibration Previous: Wavelength calibration

Line search and interactive identification

The detection of arc lines in the wavelength calibration frame \fbox{{\small \tt WLC}}.bdf (wlc) for all slitlets selected in \fbox{{\small \tt MOS}}.tbl (mos) is done by



Midas ...> SEARCH/MOS



This command will take the slitlets' limits from \fbox{{\small \tt MOS}}.tbl and the eventual stepping and binning factor from \fbox{{\small \tt YBIN}} (3,3). In all CCD rows of \fbox{{\small \tt WLC}}.bdf that are selected by these parameters it will look for intensities above the chosen threshold when comparing to the median intensity over a chosen window (threshold and window are defined by \fbox{{\small \tt SEAPAR}} (200,5)). Any lines detected this way will be centered by \fbox{{\small \tt CENTMET}} (GRAVITY) and stored in \fbox{{\small \tt LINPOS}}.tbl (linpos).


:X x-position of line (world coordinates)
:Y y-position of line (world coordinates)
:PEAK maximum intensity of line
:SLIT number of slitlet




With



Midas ...> LINPLOT/MOS



you will get a plot of the x-positions of all found arc lines versus the CCD rows. With



Midas ...> LINPLOT/MOS 1 3



you will get a plot of the first CCD row of slitlet 3 for which line positions are stored in \fbox{{\small \tt LINPOS}}.tbl. The detected lines are marked in the plot.

If you do not know the central wavelength and mean dispersion of the grism you used you have to identify at least two arc lines in any row of any slitlet.



Midas ...> IDENTIFY/MOS



The row, in which the lines shall be identified, is read from \fbox{{\small \tt YSTART}}(0). If you do not provide any number either there or on the command line, the program will take the first CCD row that has been scanned. As frame it will use \fbox{{\small \tt WLC}}.bdf.


next up previous contents
Next: Offsets between slitlets Up: Wavelength calibration Previous: Wavelength calibration
http://www.eso.org/midas/midas-support.html
1999-06-15